Skip to content

Need stainless steel fittings, valves or hose?

BSPP (G) Thread Chart (Printable)

Threads per inch and major outside diameter for BSPP G sizes 1/8″ through 2″ per ISO 228-1 — parallel threads that seal on a face, washer or gasket, never on the thread itself.

G sizes, TPI and major diameter

BSPP sizeThreads per inchMajor OD (mm)
G1/8289.728
G1/41913.157
G3/81916.662
G1/21420.955
G3/41426.441
G11133.249
G1-1/41141.910
G1-1/21147.803
G21159.614

How to use this chart

G threads are parallel — the flanks do not wedge as the joint tightens — so the seal comes from a washer, O-ring, bonded seal or a machined face, not from the thread. That is the practical difference from NPT on the bench: an NPT joint seals with tape or dope on tapered flanks, a G joint needs its sealing element seated. Dimensions follow ISO 228-1 published values; the standard governs for gauge decisions.

The fraction in a BSP size is a nominal designation, not a dimension. The "1/8" in G1/8 traces back to the nominal bore of the historic iron pipe the thread was originally cut on — it does not correspond to the thread's outer diameter, its inner diameter, or any other measurement you can take with calipers. What you can measure is defined by ISO 228-1: a G1/8 thread has a major diameter of 9.728 mm and a pitch of 28 threads per inch (about 0.907 mm). So a thread that calipers at roughly 9.7 mm across the crests is a G1/8 — even though 1/8 inch works out to just 3.175 mm, which is smaller than any dimension on the actual thread. The same nominal logic runs through the whole chart: G1/4 measures 13.157 mm and G1/2 measures 20.955 mm, neither of them anywhere near its fraction of an inch. When you are identifying a fitting from a physical part, measure the thread OD with calipers and match it against the major OD column — never convert the nominal fraction. For telling BSP apart from NPT on the bench, seeidentifying NPT vs BSP threads; theNPT chartfollows the same nominal-vs-actual convention.

From our guide: NPT vs G (BSP) threads. State G-thread sizes as "G1/2" plus the sealing element on theRFQ.