Skip to content

Need stainless steel fittings, valves or hose?

Stainless Steel Push-to-Connect (Push-In) Fittings

5 products

Push-in straight, elbow, union and bulkhead fittings for rapid tube changes on pneumatic and utility lines. Separate series from quick-screw.

How to order: Push-to-connect is for compatible tube OD and hardness — typically air and light utilities, not steam. Confirm OD before ordering.

Open a card for material, ends and ordering. Price is on the quote.

Push-to-Connect Straight Fitting — FerruleX stainless steel fittings

Push-to-Connect Straight Fitting

Push-to-Connect Straight Fitting: stainless push-in tube fitting for air/water. SS304/316. FerruleX RFQ. Stocked sizes ship fast. Export RFQ only — no cart.

View details →
Push-to-Connect Elbow Fitting — FerruleX stainless steel fittings

Push-to-Connect Elbow Fitting

Push-to-Connect Elbow Fitting: 90° stainless push-in fitting for crowded bases. FerruleX factory RFQ. Stocked sizes ship fast. Export RFQ only — no cart.

View details →
Push-to-Connect Straight Union — FerruleX stainless steel fittings

Push-to-Connect Straight Union — Sizes & Specs

Push-to-Connect Straight Union: stainless push-in tube-to-tube union. SS304/316. FerruleX RFQ. Stocked sizes ship fast. Export RFQ only — no cart.

View details →
Push-to-Connect Bulkhead Fitting — FerruleX stainless steel fittings

Push-to-Connect Bulkhead Fitting — Types & Sizes

Push-to-Connect Bulkhead Fitting: panel-pass stainless push-in fitting. SS304/316. FerruleX factory RFQ. Stocked sizes ship fast. Export RFQ only — no cart.

View details →
Push-to-Connect Throttle Valve — FerruleX stainless steel fittings

Push-to-Connect Throttle Valve — 316L Air Line

Push-to-Connect Throttle Valve: stainless flow control for air lines, 4–12 mm / 1/8–1/2 in tube, to 150 psi (10 bar) class. SS304/316. FerruleX RFQ.

View details →

Choosing in this range

What tube does a push-to-connect fitting take?

Soft tube — PU or nylon for air and light fluid. The grip indents the wall; a metal tube will not deform and will not seal.

How much pressure can the joint hold?

The group is rated 1000 psi, and the joint holds it only with the right tube. Tube type and wall decide as much as the fitting body.

Can I disconnect and reconnect the same tube?

Yes, but each cycle marks the wall. Inspect the end and trim it square when the mark is deep enough to sit under the grip.

Is there a panel-mount version, and what clearance does it need?

Yes, with a bulkhead body through the plate. Leave room behind the panel to reach the release ring, or the tube cannot be removed in service.

What causes a leak right after installation?

Tube not inserted to the stop, an oval or scored end, or a bent run loading the fitting sideways. Cut, deburr and re-seat before replacing parts.